MPG - Moldable Polymer Gasket
The MPG kit allows you to make gaskets of any size and shape, these gaskets can compensate for irregularities in the surface of up to 7 mm .
Simply apply the Moldable Polymer to the surface as desired then spray with activator to start the curing process then you can close up the equipment.
-
MPG is a high quality system for the production of flat gaskets for most industrial applications
-
flange irregularities up to 7 mm can be compensated - MPG is dimensionally stable, does not shrink and warp, does not slip
-
easy installation (see figure) and removal - can be pulled off without sticking onto the object, protects flanges
-
highly economical: no waste, no cutting and punching of gaskets
-
resistant to water, oils, hydraulic fluids, solvents, chemicals, etc., except concentrated
acids / alkalines (in the pH range >2 to < 11) -
very good coverage: top surface of a cartridge (400 ml) at 3 mm bead diameter corresponds to about 33 m
-
Specifications (physical parameters):
p-range: vacuum - 220 bar (see below)
pmax (after full cure 24 hours at 25 ° C): 220 bar (depending on the conditions and mechanical tolerances to bridge the sealing gap.) pmax (immediately after application): 1 bar
pmax (steam 170 ° C): 7 bar
t: -50°C up to +260°C
pH: 2-11
